Nexus mod manager missing mod error software#
Nexus mod manager missing mod error code#
Nexus mod manager missing mod error series#

If the issue is fixed by reload, the root cause is related to Cisco bug ID CSCus22805.

If the issue is seen after reload, you need a hardware replacement.

Reload the problem Supervisor, if possible.

A reset/reboot of the board rediscovers these failed flashes are healthy at the next boot up.Д¬omplete these steps in order to verify if this is or is not a hardware issue:

Nexus mod manager missing mod error software#

There are a few instances in the field where one or both of these flashes are marked as bad by the RAID software over a time span of several months or years in service. With the redundancy, a Supervisor can function with the loss of one of the flashes but not both. These two flashes are reconfigured as a Redundant Array of Independent Disks (RAID) 1 array which implements internal mirroring. The flashes provide a repository for bootflash, configurations, and other pertinent information. Second generation Nexus 7000 Supervisors are shipped with two identical eUSB flashes for redundancy. Last failure reason -> The compact flash power test Last test failure time -> Sun Apr 13 10:07:40 2014 U = Untested, A = Abort, E = Error disabled) Diagnostic test failures: Test results: (.Error Message: DEVICE_TEST-2-COMPACT_FLASH_FAIL: Module 5 has failed test CompactFlashДў0 times on device Compact Flash due to error The compact flash power test failed.One or all of these are seen on the Supervisor 2/Supervisor 2E: If the module fails again, raise a Return Material Authorization (RMA) request for the Supervisor in the problem slot.Observe the result of the show diagnostic result module 5 and show module commands. If the NVRAM test fails again, reseat the module 5.no diagnostic monitor module 5 test NVRAMД®nterВ the show diagnostic result module 5 test NVRAM detail command in order to see the results of the test command.EnterВ these commands in order to disable and reenable the diagnostic test (example if given for problem module 5): Rerun the NVRAM test in order to see if this is a false alarm.This is either a hardware issue, a Supervisor Engine failure, or a transient issue. Last failure reason -> Bad blocks found on nvram

Last test failure time -> Wed Dec 5 01:03:42 2012 Last test execution time -> Wed Dec 5 01:03:41 2012ДЇirst test failure time -> Tue Dec 4 23:28:45 2012 #show diagnostic result module 5 test NVRAM detail Event_ERROR: TestName->NVRAM TestingType->health monitoring module->5 NVRAM errors appear in diagnostic events: Nexus7000# show diagnostic eventsДЎ) Event:E_DEBUG, length:97, at 9664 usecs after Wed Dec 5 01:03:42 2012 Refer to Nexus 7000 FAQ: What is the recommended action to take when the SpineControlBus test fails?.

This isue is related to Cisco bug ID CSCuc72466. Last failure reason -> Spine control test failed Last test failure time -> Mon May 27 21:57:17 2013

Nexus mod manager missing mod error code#

System Errorcode : 0x418b0022 Spine control test failedД®rror Description : Module 10 Spine Control Bus test FailedД®rror code -> DIAG TEST ERR DISABLE The spine control test fails for the Nexus 7000 Supervisor: Nexus7000# show module internal exceptionlog module 5 The variation depends on the software release that runs on the Supervisor Engine. Note: The exact format of the syslog and error messages that this document describes can vary slightly.

Nexus mod manager missing mod error series#

This document provides a brief explanation and solutions for common hardware and architecture issues for Cisco Nexus 7000 Series switches that run Cisco NX-OS system software.